Article ID: 000058741 Content Type: Troubleshooting Last Reviewed: 08/06/2021

Unable to See the RAID Volume or Encounter Error Partitioning Message during Red Hat Enterprise Linux* (RHEL) 6.x Installation

Environment

Intel Embedded Server RAID Technology 2 (ESRT2) Red Hat Enterprise Linux (RHEL) 6.x NoteThe RHEL OS version must also be supported by the Intel® Server Board or System.

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Summary

How to load driver for your Intel® Embedded Server RAID Technology 2 (ESRT2) controller during RHEL 6.x operating system (OS) installation

Description

Unable to install RHEL* 6.x to an Intel® ESRT2 RAID volume (virtual drive) due to either of the following:

  • Created the Intel ESRT2 RAID volume (virtual drive) in the pre-boot configuration utility but still unable to see the RAID volume.
  • Can see the RAID volume but gets the following error message:
    example image
Resolution

Follow the steps below to prepare and load the driver during RHEL installation:

  1. Download the latest Intel ESRT2 Linux driver to a Linux system and unzip the package.
  2. Open a terminal with root privilege and navigate to the DUD folder in the unzipped package.
  3. Enter the following commands to prepare the driver image:
    mkdir image
    gunzip megasr-18.02.2019.0603-l-rhel69-ga-x86_64.img.gz
    (replace the filename with the desired OS version)
    mount -oloop megasr-18.02.2019.0603-l-rhel69-ga-x86_64.img imag
  4. Copy the content in the image directory to the root of an USB drive and change the USB volume label to OEMDRV. The content of the USB should look like below:
    example image
  5. Insert the USB drive to the Intel ESRT2 system and start the RHEL installation.
  6. Navigate to Red Hat Enterprise Linux and press E.
    example image
  7. Select the line starts with kernel /images/pxeboot/vmlinuz and press E.
    example image
  8. Add the following to the end of the line then press Enter:
    linux dd blacklist=ahci nodmraid

    example image

    NoteFor Intel Server Board S2600WF/S2600ST, you will also need to add nomodeset xdriver=vesa brokenmodules=ast to the end of the line mentioned above.
  9. Press B to continue.
  10. If you have labeled the USB drive as OEMDRV, select Use it when you see below screen then select No when prompted Do you have a driver disk? and proceed to Step 14:
    example image
  11. If you did not label the USB drive as OEMDRV in Step 4, select Yes when prompted Do you have a driver disk?
  12. Select the USB device to install the driver. In this example, this is /dev/sda
    example image
  13. Select No when prompted Do you wish to load any more driver disks? and proceed with the installation.
  14. You should now see the Intel ESRT2 RAID volume and install RHEL on to this volume.
    example image
Additional information

You should not need to load driver for other Intel RAID controllers during Linux OS installation. Contact Intel Customer Support if you experience issues.

Related Products

This article applies to 102 products

Intel® Server Board S2600STK
Intel® Server Board S2600STS