Article ID: 000073650 Content Type: Troubleshooting Last Reviewed: 09/11/2012

In the BSDL file for a EP3C120F484 Version 1.02 it refers to Pin E60 but this pin is not available in this package, is this a typo?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

Yes, in the BSDL file for a Cyclone® III EP3C120 (EP3C120F484) version 1.02 there is a typo where it states pin E60 in the section that states "You must run the Boundary Scan test in post-configuration mode if any of the following pins is connected to any termination resistor: F7, C18, AA20, Y4, V5, F15, F9, AB20, E60." The E60 pin should actually be pin E16. This does not impact the operation of the BSDL file.

This will be corrected in a future version of the BSDL file.

Related Products

This article applies to 1 products

Cyclone® III FPGAs