Article ID: 000078994 Content Type: Troubleshooting Last Reviewed: 09/11/2012

What value should I use for the parameter "After how many pulses does the data alignment circuitry restore the serial latency back to 0?" in the altlvds_rx megafunction?

Environment

BUILT IN - ARTICLE INTRO SECOND COMPONENT
Description

It is recommended that you put the value equal to or greater than the deserialization factor for your implementation. If the number you set is less than the deserialization factor, you may not be able to achieve the correct word boundary because the shift register depth would not be adequate to roll through the entire word.

Related Products

This article applies to 8 products

Stratix® FPGAs
Stratix® GX FPGA
Arria® GX FPGA
HardCopy™ III ASIC Devices
Stratix® II GX FPGA
Stratix® II FPGAs
Stratix® IV GX FPGA
Stratix® III FPGAs