You can use the set_false_path command to specify your design's false paths (i.e., paths that can be ignored during timing analysis). The following list shows the available options for the set_false_path command:
set_false_path [-from <from list>] [-to <to list>] [-thru <thru list>]
Table 1 Describes the options for the set_false_path command.
|-from <from list>||The <from list> is a collection or list of objects in the design.|
|-to <to list>||The <to list> is a collection or list of objects in the design.|
|-thru <thru list>||The <thru list> is a collection or list of objects in the design. The <thru list> acts as the thru point of the path.|
When the objects are timing nodes, the false path only applies to the path between the two nodes. When the object is a clock, the false path applies to all paths where the source node (for -from) or destination node (for -to) is clocked by the clock.