Remote Update Intel® FPGA IP User Guide

ID 683695
Date 8/16/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

1.6.1. Intel Arria 10 Remote Update Design Example

This Intel® Arria® 10 design example uses the Avalon® -MM interface. Intel® uses the following hardware and software to create the design example:

  • Intel® Quartus® Prime Version : 15.0
  • Intel® Arria® 10 Development Kit with 10AX115S3F45I2SGE2 FPGA Device

Follow these steps to perform the design example tasks:

  1. Unzip the contents of the design example to your working directory on your PC.
  2. Convert the three .sof files into one .jic by using Convert Programming File. On the File Menu, click Convert Programming Files and select the details as shown below:
    • Programming File type: JTAG Indirect Configuration File (.jic).
    • Select Configuration Device: EPCQL1024.
    • Mode: Active Serial.
    • Set the file name you your desired location.
    • Flash loader: click add device and choose 10AX115S2E2.
    • SOFT DATA PAGE_0: click Add File and select the factory image with start address set to <auto>.
    • SOFT DATA PAGE_1: click Add File and select the application image file with start address 0x2000000. Compression is enabled for this application image file.
    • SOFT DATA PAGE_2: click Add File and select the application image file with start address 0x4000000. Compression is enabled for this application image file.
    • Click Generate.
    • Click OK when the dialog box of .jic file successfully generated appears.
  3. Please follow the steps below to run the simple design:
    1. After programming the .jic file, power cycle the board, all LED is lighted up. It indicates you are currently at factory image.
    2. Go to system console and direct to the directory where your FI_SysConsole_try.tcl is located. Type source FI_SysConsole_try.tcl.
    Only one LED is lighted up which indicates successfully go to application image 1. After the watchdog timeout, all LED will light up and go back to factory image.
    Note: To go to application image 2 directly form the factory image, comment out the write boot address to App1 and uncomment the write boot address App2 in the FI_SysConsole_try.tcl file.
  4. Setting Boot Page Selection for design with more than one SOF page:
    1. To select the boot page, click the Option/Boot Info button in Convert Programming File.
    2. In the Active Serial Boot Info window, select the page available from the Boot from page drop down menu. By default, the page number will be set at page_0.
    3. For application to application image, change the page number to page_1 or page_2.