Intel® Quartus® Prime Pro Edition User Guide: Partial Reconfiguration

ID 683834
Date 1/11/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

3.3.8. PR Control Block and CRC Block VHDL Manual Instantiation

The following example shows manual instantiation of a PR control block inside your top-level Intel® Arria® 10 project, Chip_Top, in VHDL:

module Chip_Top is port (
 --User I/O signals (excluding signals that relate to PR)
 ..
 ..
 )
-- Following shows the connectivity within the Chip_Top module
Core_Top : Core_Top
 port_map (
 ..
 ..
 );
m_pr : twentynm_prblock
 port map(
clk => dclk,
 corectl =>'1', --1 - when using PR from inside
 --0 - for PR from pins; You must also enable
 -- the appropriate option in Quartus Prime settings
 prrequest => pr_request,
 data => pr_data,
 error => pr_error,
 ready => pr_ready,
 done => pr_done
 );
m_crc : twentynm_crcblock
 port map(
 shiftnld => '1', --If you want to read the EMR register when
 clk => dummy_clk, --error occurrs, refer to AN539 for the
 --connectivity for this signal. If you only want
 --to detect CRC errors, but plan to take no
 --further action, you can tie the shiftnld
 --signal to logical high.
 crcerror => crc_error
 );
Note: You are not required to connect a real clock source to dummy_clk, but you must connect dummy_clk to an I/O pin to avoid removal of this signal.