Intel® Cyclone® 10 LP FPGA Evaluation Kit User Guide

Download PDF
ID 683580
Date 12/19/2019
Public
Document Table of Contents
Document Table of Contents x
1. Overview 2. Getting Started 3. Evaluation Board Setup 4. Evaluation Board Components 5. Simple Socket Server 6. Board Test System A. Safety and Regulatory Information B. Additional Information
1. Overview x
1.1. Evaluation Kit Description 1.2. Recommended Operating Conditions 1.3. Handling the Board 1.4. Evaluation Board Revisions
1.1. Evaluation Kit Description x
1.1.1. Evaluation Board Description 1.1.2. Evaluation Kit Collateral 1.1.3. Power Supply Description
2. Getting Started x
2.1. Installing Quartus Prime Software 2.2. Installing the Evaluation Kit Collateral 2.3. Installing Intel® FPGA Download Cable Driver
3. Evaluation Board Setup x
3.1. Powering Up the Evaluation Board 3.2. Default Switch Settings 3.3. Recovering Factory Default Settings
4. Evaluation Board Components x
4.1. Board Overview 4.2. Intel® Cyclone® 10 LP FPGA Overview 4.3. MAX 10 System Controller Overview 4.4. FPGA Configuration 4.5. Status Elements 4.6. Setup Elements 4.7. General User Input/Output 4.8. Clocks 4.9. Connectors and Interfaces 4.10. Memory 4.11. System Power
4.4. FPGA Configuration x
4.4.1. Using the Quartus Prime Programmer 4.4.2. Program On-Board EPCQ or EPCQ-A Flash Memory 4.4.3. Active Serial Configuration
4.9. Connectors and Interfaces x
4.9.1. Gigabit Ethernet PHY 4.9.2. 2x20 GPIO Expansion Header 4.9.3. Arduino Connectors 4.9.4. Pmod Connectors
4.9.3. Arduino Connectors x
4.9.3.1. Digital IOs 4.9.3.2. Analog Inputs 4.9.3.3. Arduino Power
4.10. Memory x
4.10.1. HyperRAM 4.10.2. EPCQ or EPCQ-A Flash Memory
4.11. System Power x
4.11.1. Power Supply Options 4.11.2. Power Tree 4.11.3. Current Measurement
5. Simple Socket Server x
5.1. Connecting to the Simple Socket Server
6. Board Test System x
6.1. The Configure Menu 6.2. The System Info Tab 6.3. The GPIO Tab 6.4. The Flash Tab 6.5. The HyperRAM Tab 6.6. The Power Monitor 6.7. The Clock Control
A. Safety and Regulatory Information x
A.1. Safety Warnings A.2. Safety Cautions
B. Additional Information x
B.1. Revision History B.2. Compliance and Conformity Statements
1. Overview
2. Getting Started
3. Evaluation Board Setup
4. Evaluation Board Components
5. Simple Socket Server
6. Board Test System
A. Safety and Regulatory Information
B. Additional Information

4.9.3.1. Digital IOs

There are 17 one-bit Arduino digital IOs on Arduino connectors which are connected to the FPGA on the board. They are all 3.3 V single-ended IOs.
CAUTION:
The Arduino interface only supports 3.3 V I/O. Care must be taken when you connect a shield into the connectors.
Level Two Title