External Memory Interfaces Intel® Cyclone® 10 GX FPGA IP User Guide

ID 683663
Date 3/29/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

10.5.3. Measure Signal Integrity and Setup and Hold Margin

Measure the signals on the PCB. When measuring any signal, consider the edge rate of the signal, not just its frequency. Modern FPGA devices have very fast edge rates, therefore you must use a suitable oscilloscope, probe, and grounding scheme when you measure the signals.

You can take measurements to capture the setup and hold time of key signal classes with respect to their clock or strobe. Ensure that the measured setup and hold margin is at least better than that reported in the Intel® Quartus® Prime software. A worse margin indicates a timing discrepancy somewhere in the project; however, this issue may not be the cause of your problem.