External Memory Interfaces Intel® Cyclone® 10 GX FPGA IP User Guide

ID 683663
Date 3/29/2021
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

5.2.6. Simulating the Design Example

This topic describes how to simulate the design example in Cadence, Synopsys* , Siemens EDA, and Aldec simulators.

To simulate the design example in the Intel® Quartus® Prime software using the Cadence simulator, follow these steps:

  1. At the Linux* shell command prompt, change directory to sim\ed_sim\cadence
  2. Run the simulation by typing the following command at the command prompt:
    sh xcelium_setup.sh

To simulate the example design in the Intel® Quartus® Prime software using the Synopsys* simulator, follow these steps:

  1. At the Linux* shell command prompt, change directory to sim\ed_sim\synopsys\vcsmx
  2. Run the simulation by typing the following command at the command prompt:
    sh vcsmx_setup.sh

To simulate the example design in the Intel® Quartus® Prime software using the Siemens EDA simulator, follow these steps:

  1. At the Linux or Windows shell command prompt, change directory to sim\ed_sim\mentor
  2. Execute the msim_setup.tcl script that automatically compiles and runs the simulation by typing the following command at the Linux or Windows command prompt:
    vsim -do msim_setup.tcl

    or

    Type the following command at the ModelSim* command prompt:

    do msim_setup.tcl
    

For more information about simulating the external memory interface using the Siemens EDA simulator, refer to the Simulating External Memory Interface IP With ModelSim chapter in the Intel® Cyclone® 10 External Memory Interfaces IP Design Example User Guide .

Note: Intel does not provide the run.do file for the example design with the EMIF interface.

To simulate the example design in the Intel® Quartus® Prime software using the Aldec simulator, follow these steps:

  1. At the Linux or Windows shell command prompt, change directory to sim\ed_sim\aldec
  2. Execute the rivierapro_setup.tcl script that automatically compiles and runs the simulation by typing the following command at the Linux or Windows command prompt: vsim -do rivierapro.tcl
  3. To compile and elaborate the design after the script loads, type ld_debug.
  4. Type run -all to run the simulation.

For more information about simulation, refer to the Simulating Designs chapter in Volume 3 of the Intel® Quartus® Prime Handbook.

If your Intel® Quartus® Prime project appears to be configured correctly but the example testbench still fails, check the known issues on the Intel FPGA Knowledge Base before filing a service request.