External Memory Interfaces Intel® Stratix® 10 FPGA IP User Guide

ID 683741
Date 3/11/2022
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

8.3.1.6.5. QDR II, QDR II+ and QDR II+ Xtreme SRAM Data, BWS, and QVLD Signals

QDR II, QDR II+ and QDR II+ Xtreme SRAM devices use two unidirectional data buses: one for writes (D) and one for reads (Q).

At the pin, the read data is edge-aligned with the CQ and CQ# clocks while the write data is center-aligned with the K and K# clocks (see the following figures).

Figure 77. Edge-aligned CQ and Q Relationship During QDR II+ SRAM Read


Figure 78. Center-aligned K and D Relationship During QDR II+ SRAM Write


The byte write select signal (BWS#) indicates which byte to write into the memory device.

QDR II+ and QDR II+ Xtreme SRAM devices also have a QVLD pin that indicates valid read data. The QVLD signal is edge-aligned with the echo clock and is asserted high for approximately half a clock cycle before data is output from memory.

Note: The Intel® FPGA external memory interface IP does not use the QVLD signal.