Intel Agilex® 7 Clocking and PLL User Guide: F-Series and I-Series

ID 683761
Date 7/13/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

6.3.3. Clock Gating Reconfiguration

You can gate (disable) and un-gate (enable) I/O PLL output clock 0 to output clock 7 of the I/O PLL. It is easily done by writing one byte to the IOPLL Reconfig IP core, with one bit corresponding to each of the I/O PLL output clocks.

To perform clock gating reconfiguration, follow these steps:

  1. Set mgmt_address[9:8] to 2’b10 to select clock gating mode and set mgmt_writedata[7:0] to indicate desired output clock to be gated.
  2. To start the clock gating reconfiguration on the I/O PLL, assert the mgmt_write signal for one mgmt_clk cycle.
  3. The gating changes may not come into effect for multiple clock cycles after mgmt_waitrequest has been de-asserted.