Arria V Hard Processor System Technical Reference Manual

ID 683011
Date 12/02/2022
Public
Document Table of Contents

6.3.5. ECC and Parity Control

The system manager can enable or disable ECC for each of the following HPS modules with ECC-protected RAM:

  • MPU L2 cache data RAM
  • On-chip RAM
  • USB 2.0 OTG controller (USB0 and USB1) RAM
  • EMAC (EMAC0 and EMAC1) RAM
  • DMA controller RAM
  • NAND flash controller RAM
  • Quad SPI flash controller RAM
  • SD/MMC controller RAM
  • DDR interfaces

The system manager can inject single-bit or double-bit errors into the MPU L2 ECC memories for testing purposes. Set the bits in the appropriate memory enable register to inject errors. For example, to inject a single bit ECC error, set the injs bit of the mpu_ctrl_l2_eccregister.

Note: The injection request is edge-sensitive, meaning that the request is latched on 0 to 1 transitions on the injection bit. The next time a write operation occurs, the data is corrupted, containing either a single or double bit error as selected. When the data is read back, the ECC logic detects the single or double bit error appropriately. The injection request cannot be cancelled, and the number of injections is limited to once every five MPU cycles.

The system manager can also inject parity failures into the parity-protected RAM in the MPU L1 to test the parity failure interrupt handler. Set the bits of the parity fail injection register (parityinj) to inject parity failures.

Note: Injecting parity failures into the parity-protected RAM in the MPU L1 causes the interrupt to be raised immediately. There is no actual error injected and the data is not corrupted. Furthermore, there is no need for a memory operation to actually be performed for the interrupt to be raised.