External Memory Interfaces Intel® Arria® 10 FPGA IP User Guide

ID 683106
Date 12/19/2023
Public

A newer version of this document is available. Customers should click here to go to the newest version.

Document Table of Contents

13.4.4. Bank Interleaving

You can use bank interleaving to sustain bus efficiency when the controller misses a page, and that page is in a different bank.
Note: Page size refers to the minimum number of column locations on any row that you access with a single activate command. For example: For a 512Mb x8 DDR3 SDRAM with 1024 column locations (column address A[9:0]), page size = 1024 columns x 8 = 8192 bits = 8192/8 bytes = 1024 bytes (1 KB)

Without interleaving, the controller sends the address to the SDRAM device, receives the data requested, and then waits for the SDRAM device to precharge and reactivate before initiating the next data transaction, thus wasting several clock cycles.

Interleaving allows banks of the SDRAM device to alternate their background operations and access cycles. One bank undergoes its precharge/activate cycle while another is being accessed. By alternating banks, the controller improves its performance by masking the precharge/activate time of each bank. If there are four banks in the system, the controller can ideally send one data request to each of the banks in consecutive clock cycles.

For example, in the first clock cycle, the CPU sends an address to Bank 0, and then sends the next address to Bank 1 in the second clock cycle, before sending the third and fourth addresses to Banks 2 and 3 in the third and fourth clock cycles respectively. The sequence is as follows:

  1. Controller sends address 0 to Bank 0.
  2. Controller sends address 1 to Bank 1 and receives data 0 from Bank 0.
  3. Controller sends address 2 to Bank 2 and receives data 1 from Bank 1.
  4. Controller sends address 3 to Bank 3 and receives data 2 from Bank 2.
  5. Controller receives data 3 from Bank 3.

The following figure shows how you can use interleaving to increase bandwidth.

Figure 114. Using Interleaving to Increase Bandwidth


The controller supports three interleaving options:

Chip-Bank-Row-Col (or CS-BG-Bank-CID-Row-Col)This is a noninterleaved option. Select this option to improve efficiency with random traffic

Chip-Row-Bank-Col (or CS-CID-Row-Bank-Col-BG)This option uses bank interleaving without chip select interleaving. Select this option to improve efficiency with sequential traffic, by spreading smaller data structures across all banks in a chip.

Row-Chip-Bank-Col (or CID-Row-CS-Bank-Col-BG)This option uses bank interleaving with chip select interleaving. Select this option to improve efficiency with sequential traffic and multiple chip selects. This option allows smaller data structures to spread across multiple banks and chips.

Bank interleaving is a fixed pattern of data transactions, enabling best-case bandwidth and latency, and allowing for sufficient interleaved transactions between opening banks to completely hide tRC. Optimum efficiency is achieved for bank interleave transactions with 8 banks.